Our oldroyd plaster membrane kit covers 7.5m² (1.5m x 5m). If you are looking for a wateroroof membrane for basement renovation, damp internal walls or are experiencing problems with penetrating damp, this kit could be your answer.
The kit includes
- 1.5m x 5m roll of Oldroyd P
- 100 x Oldroyd Plaster Plugs with Seal
- 6m Roll of Oldroyd Sealing Tape
Oldroyd 'P' Plaster Membrane is a studded polypropylene waterproofing membrane with a special mesh welded to one side. It is fixed to damp, contaminated walls using Oldroyd Plaster Plugs, with the studs facing the wall. This creates an air-gap which allows the wall to breathe whilst blocking the passage of moisture. On the reverse side of the membrane, the special mesh can be plastered onto, allowing a dry plaster finish to be achieved without the risk of contamination from any damp or salts in the wall.
Typical areas of application include
- Covering damp & contaminated walls
- Basement conversion projects
- Barn conversion projects
- Protection against penetrating damp
Oldroyd 'P' can be used above or below ground, however, we recommend that our technical department is consulted before using the product below ground.Oldroyd 'P' Plaster Membrane is especially useful in situations where a damp wall is contaminated by salts or the residue of previous attempts to waterproof the wall (such as bitumen). Unlike cementitious, epoxy, or bitumen coatings, Oldroyd P can be applied directly to contaminated surfaces with minimal preparation.As an alternative to a plaster finish, plasterboard can be applied directly to Oldroyd 'P'. The plasterboard is attached to the Oldroyd 'P' by applying dabs of bonding compound to the heads of the Oldroyd Plaster Plugs that are used to attach the membrane to the wall.
Oldroyd P is also available in 2m x 20m (40m2) rolls.
Oldroyd P Plaster Membrane now carries BBA approval