Chloride and Sulphate Salt Neutraliser 5L

Chloride and Sulphate Salt Neutraliser is a solvent free salt neutraliser which targets Chlorides and Sulphates. It converts water soluble salts into insoluble or hardly
soluble reactive compounds. As a result of this neutralisation Chlorides and Sulphates which are present in the masonry cannot be transported by the gauging solution used in a Tanking Slurry coat or Fillet Seal. May be brushed onto existing plaster surfaces to neutralise emerging salts. Suitable for use on brick, blockwork, stonework, sound render and sound plaster

Instructions for Use:
Chloride and Sulphate Salt Neutraliser is supplied as a concentrate for dilution with water prior to use. All preparatory work to the substrate should be carried out in accordance with the recommendations on the relevant Data Sheet. Apply to the prepared substrate in two operations.

1st Operation:
Dilute one part of Chloride and Sulphate Salt Neutraliser with two parts of water and apply.
2nd Operation:
Allow a minimum of three hours following first operation and then apply one part of Chloride and Sulphate Salt Neutraliser which has been diluted with one part of water.
Allow 24 hours prior to the application of a tanking slurry or fillet seal.

Coverage:
Approximately 500ml/m2 for two operations.

Storage:
Chloride and Sulphate Salt Neutraliser is available in 5kg plastic containers. Protect from
frost and keep container closed. Once opened a storage life of 12 months is expected.